Canon 2010F manual Feeder ADF-J1

3

Basic Sending

Feeder (ADF-J1)

Place a stack of originals in the feeder ➞ press [Start]. The machine automatically scans them into memory.

You can place the following originals into the original supply tray:

•Weight: 10 to 32 lb bond (37 to 128 g/m2)

Place very thin originals (10 to 14 lb bond [37 to 51 g/m2]), or very thick originals (28 to 32 lb bond [105 to 128 g/m2]) into the feeder one at a time.

• Size: 11'' x 17'' , LGL , LTR , or LTR .

•Tray Capacity: 50 sheets (20 lb bond [80 g/m2])

25 sheets (11 lb bond [40 g/m2] or less)

IMPORTANT

•Do not place the following types of originals in the feeder:

-Originals with tears or large binding holes

-Severely curled originals or originals with sharp folds

-Clipped or stapled originals

-Carbon backed paper or other originals which might not feed smoothly

-Transparencies and other highly transparent originals

•Avoid scanning the same original using the feeder more than approximately 30 times. Scanning the same original repeatedly may result in the original becoming folded or torn, which in turn could cause a paper jam.

•If the feeder rollers are dirty from scanning an original written in pencil, perform the feeder cleaning procedure. (See Chapter 7, “Routine Maintenance,” in the Reference Guide.)

1 Neatly place your originals face up in the original supply tray.

Place your originals as far into the feeder as they will go.

A beep sounds when the originals are set correctly.

3-10Placing Originals