2-1006
Catalyst 6500 Series Switch Command Reference—Release8.1
78-15474-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands show qos maps
show qos mapsTo display the mapping of different maps, use the show qos maps command.
show qos maps {config | runtime} [cos-dscp-map | ipprec-dscp-map | dscp-cos-map |
policed-dscp-map [normal-rate | excess-rate] | dscp-mutation-table-map
[mutation_table_id]]
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines You can enter the config keyword to display information that was configured throu gh the CLI and saved
in NVRAM, regardless of the current runtime information.
If you do not specify an option, all maps are displayed.
Note When a switchover occurs, you cannot view the ACLs and policers deployed using COPS-DS until the
COPS-DS client on the new active supervisor engine establishes connection to the PDP and downloads
the QoS policy. The runtime fields in the output display will be blank until QoS policy is do wnload ed to
the new active supervisor engine.
If you do not enter a mutation_table_id argument, the system displays all DSCP mutation maps.
config Displays NVRAM QoS configuration.
runtime Displays current QoS configuration.
cos-dscp-map (Optional) Specifies the CoS-to-DSCP map.
ipprec-dscp-map (Optional) Specifies the IP precedence-to-DSCP map.
dscp-cos-map (Optional) Specifies the DSCP-to-CoS map.
policed-dscp-map (Optional) Specifies the marked-down map.
normal-rate (Optional) Specifies normal rate.
excess-rate (Optional) Specifies excess rate.
dscp-mutation-table-map (Optional) Specifies a DSCP mutation table map.
mutation_table_id (Optional) Number of the mutation table; valid values are from 1 to 15.
See the “Usage Guidelines” section for more information.