2-574
Catalyst 6500 Series Switch Command Reference—Release8.1
78-15474-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set snmp trap
Defaults The default is SNMP traps are disabled.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines This command is not supported by the NAM.
An IP permit trap is sent when unauthorized access based on the IP permit list is attempted.
Use the show snmp command to verify the appropriate traps were configured.
To use this command, you must configure all notification tables: snmpTargetAddrTable,
snmpTargetParamsTable, and snmpNotifyTable.
Use the all option to enable or disable all trap types and all port traps.
Use the set port trap command to enable or disable a single port or a range of ports.
The trap configuration is saved in NVRAM and the configuration file.
Examples This example shows how to enable SNMP chassis traps:
Console> (enable) set snmp trap enable chassis
SNMP chassis alarm traps enabled.
Console> (enable)
This example shows how to enable all traps:
Console> (enable) set snmp trap enable
All SNMP traps enabled.
Console> (enable)
This example shows how to disable SNMP chassis traps:
Console> (enable) set snmp trap disable chassis
SNMP chassis alarm traps disabled.
Console> (enable)
This example shows how to enable SNMP MAC address notification traps:
Console> (enable) set snmp trap enable macnotification
SNMP MAC notification trap enabled.
Console> (enable)
This example shows how to add an entry in the SNMP trap receiver table:
Console> (enable) set snmp trap 192.122.173.42 public
SNMP trap receiver added.
owner
rcvr_owner (Optional) Specifies the user who configured the settings for the SNMP
trap; the valid value is a character string from 1 to 21 characters in length.
index rcvr_index (Optional) Specifies index entries with the same rcvr_addr; valid values
are from 0 to 65535.