2-485
Catalyst 6500 Series Switch Command Reference—Release8.1
78-15474-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set qos acl mac
Case sensitive
Cannot be a number
Must not be a keyword; keywords to avoid are all, default-action, map, help, and editbuffer
The src_mac_addr_spec is a 48-bit source MAC address and mask and entered in the form of
source_mac_address source_mac_address_mask (for example, 08-11-22-33-44-55 ff-ff-ff-ff-ff-ff).
Place ones in the bit positions you want to mask. When you specify the src_mac_addr_spec, follow these
guidelines:
The source_mask is required; 0 indicates a “care” bit, and 1 indicates a “don’t-care” bit.
Use a 32-bit quantity in 4-part dotted-decimal format.
Use the keyword any as an abbreviation for a source and source-wildcard of 0.0.0.0
255.255.255.255.
Use host source as an abbreviation for a source and source-wildcard of source 0.0.0.0.
The dest_mac_spec is a 48-bit destination MAC address and mask and entered in the form of
dest_mac_address dest_mac_address_mask (for example, 08-00-00-00-02-00/ff-ff-ff-00-00-00). Place
ones in the bit positions you want to mask. The destination mask is mandatory. When you specify the
dest_mac_spec, use the following guidelines:
Use a 48-bit quantity in 6-part dotted-hexadecimal format for the source address an d mask.
Use the keyword any as an abbreviation for a source and source-wildcard of 0.0.0.0 ff-ff-ff-ff-ff-ff.
Use host source as an abbreviation for a destination and destination-wildcard of destination 0.0.0.0.
Valid names for Ethertypes (and corresponding numbers) are Ethertalk (0x809B), AARP (0x80 53) ,
dec-mop-dump (0x6001), dec-mop-remote-console (0x6002), dec-p hase-iv (0x6003), dec-lat (0x6004),
dec-diagnostic-protocol (0x6005), dec-lavc-sca (0x6007), dec-amber (0x6008), de c-mumps (0x 6009),
dec-lanbridge (0x8038), dec-dsm (0x8039), dec-netbios (0x8040), dec-msdos (0x8041),
banyan-vines-echo (0x0baf), xerox-ns-idp (0x0600), and xerox-address-tra nslat ion ( 0x0601) .
The ether-type is a 16-bit hexadecimal number written with a leading 0x.
Use the show security acl command to display the list.
Note The PFC3 does not provide QoS support for IPX traffic.
Examples This example shows how to create a MAC access list:
Console> (enable) set qos acl mac my_MACacl trust-cos aggregate my-agg any any
my_MACacl editbuffer modified. Use `commit' command to apply changes.
Console> (enable)
Related Commands clear qos acl
commit
rollback
show qos acl info