2-1019
Catalyst 6500 Series Switch Command Reference—Release8.1
78-15474-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
show rate-limit
show rate-limit
To display rate-limiter settings and information, use the show rate-limit command.
show rate-limit
Syntax Description This command has no keywords or arguments.
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines In the command output, the rate-limit status could be one of the following:
•On indicates a rate for that particular case has been set.
•Off indicates that the rate-limiter type has not been configured, and th e pac k e ts f or th a t ca se are not
rate limited.
•On/Sharing indicates that a particular case (not manually configured) is affected by the
configuration of another rate limiter belonging to the same sh ari ng gro up.
Examples This example shows how to display rate-limiter settings and information:
Console> show rate-limit
Configured Rate Limiter Settings:
Rate Limiter Type Status Rate (pps) Burst
-------------------- ------ -------------- -----
VACL LOG On 2500 1
ARP INSPECTION On 500 1
MCAST NON RPF Off * *
MCAST DFLT ADJ On 100000 100
MCAST DIRECT CON Off * *
ACL INGRESS BRIDGE Off * *
ACL EGRESS BRIDGE Off * *
L3 SEC FEATURES Off * *
FIB RECEIVE Off * *
FIB GLEAN Off * *
MCAST PARTIAL SC Off * *
RPF FAIL On 500 10
TTL FAIL Off * *
No Route On 500 10
ICMP UNREACHABLE On 500 10
ICMP REDIRECT Off * *
MTU FAIL Off * *
Console>