Dell B5460DN manual Installing optional trays

Additional printer setup 31

Install the printer and any hardware options you have purchased in the following order:

•Caster base

•2100‑sheet tray or spacer

•Optional 550‑sheet tray

•Printer

For more information on installing a caster base, optional 550‑sheet tray, spacer, or 2100‑sheet tray, see the setup sheet that came with the option.

Installing optional trays

CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more trained personnel to lift it safely.

CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for stability. You must use either a printer stand or printer base if you are using a high-capacity tray or more than one option. If you purchased a printer with a similar configuration, you may need additional furniture. For more information, contact the place where you purchased the printer.

1Turn off the printer.

2Unpack the optional tray, and then remove all packing material.

3Pull out the tray, and then remove any packing material from inside the tray.

4Insert the tray.

5Place the tray near the printer.