Safety information
Connect the power cord to a properly grounded electrical outlet t hat is near the product and easily accessible.
Do not place or use this product near water or wet locations.
CAUTION—POTENTIAL INJURY: This product uses a laser. Use of controls or adjustments or performance of
procedures other than those specified herein may resu lt in hazardous radiation exposure.
This product uses a printing process that heats the print media, and the heat may cause the media to release emissions .
You must understand the section in your operating instructions that discusses the guideli nes for selecting print media
to avoid the possibility of harmful emissions.
CAUTION—POTENTIAL INJURY: The lithium battery in this product is not intended to be replaced. There is a
danger of explosion if a lithium battery is incorrectly replaced. Do not recharge, disassemble, or incinerate a
lithium battery. Discard used lithium batteries according to the manufacturer's instructions and local
regulations.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
CAUTION—POTENTIAL INJURY: To reduce the risk of equipment instability, load each tray separately. Keep all
other trays closed until needed.
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or
printer damage:
•Turn off the printer, and then unplug the power cord from th e electrical outlet.
•Disconnect all cords and cables from the printer.
•If two or more optional finishers are installed, then remov e the finishers individually from the printer.
Notes:
–Make sure to remove the topmost finisher first.
–To remove the finisher, hold the finisher on both sides, and then lift the latc hes to unlock the finisher.
•If the printer does not have a caster base but is configured with optiona l trays, then remove the trays.
Note: Slide the latch on the right side of the optional tray toward the front of the tray until it clicks into place.
•Use the handholds located on both sides of the printer to lift it.
•Make sure your fingers are not under the printer when you set i t down.
•Make sure there is adequate clearance around the printer.
•Use only the power cord provided with this product or the manufacturer's authorized replacement.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, t hen turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any ot her devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the printer,
unplug the power cord from the electrical outlet and disconnect all cables from the printer before proceeding.
Use only the power cord provided with this product or the manufacturer's authorized replacement.
CAUTION—SHOCK HAZARD: Make sure that all external connections (such as Ethernet and telephone system
connections) are properly installed in their marked p lug-in ports.
Safety information 6