Troubleshooting

188

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Tray [x] paper size unsupported

The paper size in the specified tray is unsupported. Replace it with a supported paper size.

Unformatted flash detected [53]

Try one or more of the following:

From the printer control panel, press to stop the defragmentation and continue printing.

Format the flash memory device.

Note: If the error message remains, then the flash memory device may be defective and need to be replaced.

Unsupported disk

An unsupported disk has been inserted. Remove the unsupported disk, and then install a supported one.

Unsupported option in slot [x] [55]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the unsupported option card from the printer controller board, and then replace it with a supported card.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Page 188
Image 188
Dell B5460DN Too many flash options installed, Too many trays attached, Tray x paper size unsupported, Unsupported disk