Additional printer setup

26

To install a printer hard disk onto the ISP:

aRemove the screws attached to the printer hard disk mounting bracket, and then remove the bracket.

bAlign the standoffs of the printer hard disk to the holes in the ISP, and then press the printer hard disk down until the standoffs are in place.

Installation warning: Hold only the edges of the printed circuit board assembly. Do not touch or press on the center of the printer hard disk. Doing so may cause damage.

cInsert the plug of the printer hard disk interface cable into the receptacle of the ISP. Note: The plugs and receptacles are colorcoded.

Page 26
Image 26
Dell B5460DN manual