Additional printer setup

40

5Turn off the printer, and then disconnect the Ethernet cable. Then wait for at least five seconds, and then turn the printer back on.

6To verify if your printer is connected to the network, print a network setup page. Then in the Network Card [x] section, see if the status is “Connected”.

For more information, see the “Verifying printer setup” section of the User’s Guide.

Changing port settings after installing a new network Internal Solutions Port

When a new Internal Solutions Port (ISP) is installed in the printer, the printer configurations on computers that access the printer must be updated since the printer will be assigned a new IP address. All computers that access the printer must be updated with this new IP address.

Notes:

If the printer has a static IP address, then you do not need to make any changes to the computer configurations.

If the computers are configured to use the network name, instead of an IP address, then you do not need to make any changes to your computer configurations.

If you are adding a wireless ISP to a printer previously configured for an Ethernet connection, then make sure the printer is disconnected from the Ethernet network when you configure the printer to operate wirelessly. If the printer is not disconnected from the Ethernet network, then the wireless configuration will complete, but the wireless ISP will not be active. To activate the wireless ISP, disconnect the printer from the Ethernet network, turn off the printer, and then turn it back on.

Only one network connection is active at a time. To switch between Ethernet and wireless connection types, turn off the printer, connect the cable (to switch to an Ethernet connection) or disconnect the cable (to switch to a wireless connection), and then turn the printer back on.

For Windows users

1Open a Web browser, and then type the printer IP address in the address field.

Notes:

View the printer IP address on the printer control panel. The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.

If you are using a proxy server, then temporarily disable it to load the Web page correctly.

2Click , or click Start and then click Run.

3In the Start Search or Run dialog, type control printers.

4Press Enter, or click OK.

5Locate the printer that has changed.

Note: If there is more than one copy of the printer, then update all of them with the new IP address.

6Rightclick the printer.

7Click Properties > Ports tab.

8Select the port from the list, and then click Configure Port.

9Type the new IP address in the “Printer Name or IP Address” field.

10Click OK > Close.

Page 40
Image 40
Dell B5460DN manual Click Properties Ports tab