Freescale Semiconductor Microcontrollers Run Till Cycle Command, View Register Files Command

RS08 Full Chip Simulation
Configuration Procedure
551 Microcontrollers Debugger Manual
Run Till Cycle Command
This menu option, which corresponds to the GOTOCYCLE command, brings up an input
dialog box which allows the user to specify a given cycle value. When the master cycle
counter for the simulator reaches the input value, simulation halts.
Figure 24.7 Run Till A Specific Cycle Dialog Box
View Register Files Command
The View Register Files selection in the RS08FCS menu also gives the user the option of
running the register file viewer/editor. If register files are available for the device that you
have chosen, the Choose a Register Block window (see Figure 24.8) opens. You may
also open it by entering the R command in the Command Window command line.
Figure 24.8 Choose A Register Block Dialog Box
If register files have been installed on the host computer, selecting a block brings up the
Register Block register listing (see Figure 24.9), which shows a list of the files, their
addresses, and their descriptions. This begins interactive setup of system registers such as
I/O, timer, and COP watchdog.