Freescale Semiconductor Microcontrollers Configure Terminal Connections

ColdFire V1 Full Chip Simulation Connection
FCS Visualization Utilities
632 Microcontrollers Debugger Manual
Configure Terminal Connections
The terminal window is very flexible and can redirect characters received from any
available input device to any available output device. You can specify these connections
by choosing Configure Connections in the context menu of the terminal component. This
opens the dialog box shown in Figure 28.64.
Figure 28.64 Configure Terminal Connections Dialog Box
You can choose one of the default configurations in the Default Configuration combo
box. The Connections section lists all active connections in a list box. There you can
customize which input devices to redirect to which output devices by adding and
removing connections.
To add a connection, specify the source and target devices using the From and To combo
boxes and then press the Add button. The new connection appears in the active connection
list below.
To remove connections, select them in the list of active connections and press the Remove
button.
In the Serial Port section you can specify which serial port to use and its properties. This
is only possible if at least one connection from or to the serial port exists.