Freescale Semiconductor Microcontrollers Default Layo ut Configu ration

Debugger Engine Environment Variables
Local Configuration File (usually project.ini)
845 Microcontrollers Debugger Manual
Default Layout Configuration (PROJECT.INI)
The default layout activated when starting the Debugger is defined in the PROJECT.INI
file located in the project directory, as shown in Listing 35.1. All default layout-related
parameters are stored in section [DEFAULTS].
Listing 35.1 Example Content of PROJECT.INI:
[HI-WAVE]
Window0=Source 0 0 60 30
Window1=Assembly 60 0 40 30
Window2=Procedure 0 30 50 15
Window3=Terminal 0 45 50 15
Window4=Register 50 30 50 30
Window5=Memory 50 60 50 30
Window6=Data 0 60 50 15
Window7=Data 0 75 50 15
Target=Sim
Target: Specifies the target used when starting the Debugger (loads the file <target> with
a .tgt extension), for example, Target=Sim for HC(S)08 Freescale Full Chip Simulator,
or Target=Motosil, Target=Bdi.
Window<n>: Specifies coordinates of the windows that must be open when the Debugger
is started. The syntax for a window is:
Window<n>=<component> <XPos> <YPos> <width> <height>
where n is the index of the window. This index increments for each window and
determines the sequence in which windows open. In the case of overlapping windows, this
index determines which windows appear on top of other windows. Values for the index
must be in the range 0–99.
Component specifies the component type to open, for example, Source, Assembly.
XPos specifies the X coordinate of the top left corner of the component (in percentage
relative to the width of the main application client window).
YPos specifies the Y coordinate of the top left corner of the component (in percentage
relative to the height of the main application client window).
width specifies the width of the component (in percentage relative to the width of the
main application client window).
height specifies the height of the component (in percentage relative to the height of the
main application client window).