Freescale Semiconductor Microcontrollers SLCDI Command

HC08 Full Chip Simulation
Configuration Procedure
299 Microcontrollers Debugger Manual
Example
>SLCCLR
Clear input and output buffer for SLC simulation
SLCDI Command
The SLCDI command is used to simulate SLIC input packets. The first input must be of
type “identifier.” Subsequent bytes may either be “data” or “identifier.” After the SLIC
Data IN buffer is filled with some data, the SLIC simulation module begins reception of
the data packet as soon as it is properly configured and turned on within the user’s
firmware. In Byte Transfer Mode, the designation of a byte as either “data” or “identifier”
has no effect. The SLIC data input buffer can store up to 256 bytes.
Syntax
SLCDI
Example
SLCDI
Bring up the SLIC IN buffer.
Figure 11.44 SLIC Data Input Configuration Dialog Box
Figure 11.45 SLIC Input Data Buffer