Freescale Semiconductor Microcontrollers 7-Segments Display Setup

ColdFire V1 Full Chip Simulation Connection
FCS Visualization Utilities
623 Microcontrollers Debugger Manual
7-Segments Display Setup
The 7-Segments Display dialog box shown in Figure 28.54 allows you to select the
display and related value.
Figure 28.54 7-Segments Display Dialog Box (Setup)
In the Select a display section, you can insert an address (in hexadecimal) to select the
display. In the Segment Activation field, you can set the value of this display. The
predefined port is the one used when this component works with the Programmable
IO_Ports Component.
Control Bits Configuration
The two bytes sent to the 7-segments display must be composed as shown in Figure 28.55.
Figure 28.55 Seven Segments Display Control Bits
NOTE The 7-segments display component in FCS is much slower than its real
equivalent. In simulation it is not necessary to insert delays between each
display scan (for segments light on and observer eye perception).
Drag Out:
Nothing can be dragged out.