Guardian Technologies N7001V2, VISTA-40 Installing the Control, Installing the Lock, 10 Ð

Section 2. INSTALLING THE CONTROL

MOUNTING THE CABINET

General The VISTA-40 is supplied with a 12.5"W x 14.5"H x 3"D cabinet suitable for use in residential and non-certified commercial burglary installations.

Mount the Control cabinet to a sturdy wall using fasteners or anchors (not supplied) in a clean, dry area which is not readily accessible to the general public. The back of the Control cabinet has 4 holes for this purpose.

Follow the instructions below for mounting the VISTA-40 PC board into the cabinet and for mounting the Control's lock to its cabinet door.

Mounting The Before mounting the circuit board, be certain that the appropriate metal PC Board knockouts have been removed. Do not attempt to remove the

knockouts after the circuit board has been installed.

1.Hang the three mounting clips on the raised cabinet tabs. Observe proper clip orientation to avoid damage to the clip when mounting screws are tightened and to avoid problems with insertion and removal of the PC board.

2.Insert the top of the circuit board into the slots at the top of the cabinet. Make certain that the board rests in the slots as indicated in step 2 detail.

3.Swing the base of the board into the mounting clips and secure the board to the cabinet with the accompanying screws (as illustrated in step 3 detail).

Advisory Make certain that the mounting screws are reasonably tight to ensure that there is a good ground connection between the PC board and the cabinet. Also, dress field wiring away from the microprocessor (center) section of the PC board. The cabinet provides 2 loops on its left and right sidewalls for anchoring field wiring using tie wraps. These steps are important to minimizing the risk of panel RF interference with television reception.

A B

3RD CLIP REQUIRED

DETAIL SIDE VIEW OF CLIP INSTALLATION

A-CABINET TAB WITHOUT CLIP

B-CABINET TAB WITH HANGING CLIP

MOUNTING THE PC BOARD

DETAIL SIDE

VIEW OF BOARD

INSERTED INTO

SLOTS

DETAIL SIDE VIEW OF CLIP AND BOARD INSTALLED

Installing the Lock

1.	Remove the lock knockout on the
	control cabinet cover. Insert the key
	into the lock. Position the lock in the
	hole making certain that the latch will
	make contact with the latch bracket
	when the door is closed.
2.	While holding the lock steady, insert
	the retainer clip into the retainer
	slots.
3.	Hold the lock steady, and insert the
	retainer clip into the retainer slots.
	Position the clip as illustrated in

LOCKED

RETAINER

CLIP

UNLOCKED

RETAINER CLIP

(NOTE POSITION)

RETAINER

SLOTS

order to permit easy removal.

CABINET DOOR BOTTOM

Ð 10 Ð