Section 7. SETTING THE REAL-TIME CLOCK

PROCEDURE

IMPORTANT: This method is different from the previous method of setting the clock.

NOTE: A 6139 alpha keypad must be used to set the real-time clock, or the clock can be set via the Downloader software. Only users with installer or master authority level can set the real-time clock.

To enter real-time clock mode, enter installer or master code + #63. A typical display will show:

TIME/DATE Ð THU 12:01 AM 11/07/96

The day of the week is automatically calculated based on the date entered. Time and date entries are made by simply entering the appropriate hour, minute, month, day and year. Pressing the [*] key accepts the entered value and moves the cursor to the right. Pressing the [#] key moves the cursor to the left of the display, to the previous position.

To set the time and date, simply enter the correct hour, then press [*] to move to the minutes and make the correct entry.

Press [*] again, then toggle the AM/PM by pressing any key 0Ð9.

Press [*] to move cursor to the month position and enter the correct month using a 2-digit entry.

Press [*] and enter the correct date.

Press [*] and enter the correct year.

To exit clock mode, press the [*] key after the cursor is in the year position.

Time adjustments for daylight savings time are handled automatically by the system (see data field options 2*01 and 2*02).

Ð 87 Ð

Page 87
Image 87
Guardian Technologies VISTA-40, N7001V2 installation instructions Setting the REAL-TIME Clock, Procedure, 87 Ð