Guardian Technologies VISTA-40, N7001V2 Vim, Pabx, Standard Phone Line Connections

PHONE LINE CONNECTIONS

Standard Phone Line	IMPORTANT!: If using a 4285 Phone Module, phone connections must be
Connections	made exactly as shown in the PHONE MODULE section, even if the system is
	not programmed to communicate with a monitoring station. The 4285 Phone
	Module will not function unless the system is wired exactly as
	described.
	Incoming phone line and handset wiring is connected to the main terminal block
	as follows (refer to Diagram below):
	TB1-26: Local Handset (TIP)
	TB1-27: Local Handset (RING)
	TB1-28: Incoming Phone Line (TIP)
	TB1-29: Incoming Phone Line (RING)
Warning:	To prevent the risk of shock, disconnect phone lines at telco jack before servicing
	the panel.
	If you want to connect the control panel to phone lines that require ground start
	capability, you must use a 675 Ground Start Module must be used. This module
	is triggered by one of the outputs on the connector labeled J7 (see VOLTAGE
	TRIGGERS section).
Voice Interface Module	Be sure to connect the VIM unit to the control's handset terminals 26 and 27.
(VIM)	Refer to the 2-WAY VOICE KEYPADS AND AUDIO ALARM VERIFICATION
	section later in this manual for wiring diagram.
PABX	If the communicator is connected to a telephone line inside a PABX, be sure the
	PABX has a back-up power supply that can support the PABX for 24 hours. Many
	PABXs are not power backed up and connection to such a PABX will result in a
	communication failure if power is lost.

TERMINALS

ON CONTROL á

{			{GROUND
Handset		Incoming
		Telco Line
26	27	28		29	30
BROWN(TIP)	(RING)GRAY	GREEN(TIP)		(RING)RED	DIRECT
					CONNECT
					CORD

s

EARTH GROUND

		INCOMING TELCO LINE
TIP			RING
				s
		s			TIP
	RJ31X					PREMISES
					RING
	JACK
						PHONES

PLUG

STANDARD PHONE LINE CONNECTIONS

Ð 11 Ð