Guardian Technologies VISTA-40, N7001V2 Input Type RF TRANS. RF Loop Number, Prog AS RF1, 57 Ð

Zone Programming (continued)

20INPUT TYPE RF TRANS. RF:

Note that input types 4 & 5 are valid for certain 5800 series transmitters only (ex. 5801, 5802, 5802CP). When using 5700 series transmitters, always set the input type to type 3. The zone number of the transmitter identifies whether or not supervision is required (ex. 5700 wireless zone number 63 is not supervised).

20 LOOP NUMBER

OR

20 LEARN S/N ? 1=YES 0=NO

20 INPUT S/N : L

A000-0000: 1

Enter the device type as follows: 0=device not used; 1=hardwired; 3=supervised RF transmitter (RF); 4=unsupervised RF transmitter (UR); 5=RF button type transmitter (BR); 6=serial number polling loop device (SL); 7=DIP switch type polling loop device (DP); 8=right loop of DIP switch type device (PS).

Right loops refer to the use of the right loop on a 4190WH zone expander module and/or 4278 PIR, which allow hard-wired devices to be monitored by the polling loop.

If the zone was programmed as input type 1, 7 or 8, the summary display appears. The display will then repeat with the zone number question for programming the other zones in the system. Enter 00 to exit back to normal programming mode.

If this is a previously "enrolled" sensor, the loop number for this zone will appear. Press [*] to continue.

If the sensor's serial number has not been "enrolled," the serial number can be enrolled now by entering 1, or it can be enrolled later by using the ÒSerial Number Enrolling/DeletingÒ menu (see next section). Enter 0 if serial number will be enrolled later. The summary screen will then appear (see summary screen description on previous page).

If enrolling the serial number now (entering 1 at the last prompt), this prompt appears. You can enroll transmitter serial numbers using either of two methods.

A.Fault the transmitter two times. The keypad will beep twice when it hears each transmission. When enrolling transmitters assigned as BR input type (e.g. 5802, 5802CP), allow 8 seconds between transmissions.

OR

B.Enter the serial number directly from the keypad. The serial number is located on the bar code label of the transmitter. Simply enter the 7-digit number following the letter "A" then press [*]. Enter the appropriate loop number for the zone being programmed and press [*].

When the serial number has been successfully enrolled, its number appears in the display. A typical display is shown below:

20 PROG AS RF:1

A001-3078:1

Press [*] to continue. The summary screen will then appear (see summary screen description on previous page).

Ð 57 Ð