Guardian Technologies N7001V2, VISTA-40 Enrolling Through Sequential Mode #93

10 ZT P RC IN:L s 03 1 00 RF:1

At any time during this step, you may press the [✱] key on the keypad or the upper left-hand button of the program tool if you are satisfied with the serial and loop number combination that has been enrolled, regardless of whether or not the enrolled input has been "confirmed."

If the incorrect device has been enrolled, press the # key on the keypad or upper right-hand button on the program tool to delete the serial number and return to the "LEARN S/N" prompt. A single long beep will be heard from the keypad to verify pressing of the upper right-hand button. Then, press "1" (Yes) or press the upper left-hand button of the program tool (a single short beep will verify the system is ready for enrolling) and re-activate the proper device loop input.

14.The summary screen for the zone will appear. Note that an "s" indicates that a serial number has, in fact, been enrolled. Press [✱] to accept the zone information.

If you want to delete the serial number, press [#]. This will bring you back to step 8. Press [✱] to change input type, loop number, and serial number.

When you have finished programming all zones, test each using the system's TEST mode. Do not use the Transmitter ID Sniffer mode for this, as it will only check for transmission of one zone on a particular transmitter, NOT the zones assigned to each additional loop, and will not verify polling loop type zones.

ENROLLING THROUGH SEQUENTIAL MODE (#93)

(Use this mode only after all other zone information has been programmed, including transmitter loop numbers).

PROGRAM TOOL? 0 = NO, 1 = YES 0

00INPUT S/N: L Axxx-xxxx

To enroll devices sequentially, after all other zone information has been programmed, do the following:

1.Enter Programming mode [Installer Code] + 8 + 0 + 0 on an alpha keypad. Enter Sequential mode by pressing #93. Press 0 repeatedly until the "SEQUENTIAL LEARN" prompt is displayed. Enter "1" to enroll a device's serial number. The following prompt will appear:

2.If using a program tool, enter "1." If not using a tool, enter "0." If a tool has already been programmed, this prompt will not appear. If either not using a tool or one has already been programmed, skip to step 4.

3.If "1" is entered, the system will prompt for the unit’s serial number. Enter the program tool’s serial number using one of the following methods:

a)Enter the 7-digit serial number printed on the transmitter or

b)Press any button on the transmitter. The keypad should beep three times and display the serial number of the tool.

Ð 4 Ð