Guardian Technologies VISTA-40, N7001V2 An input type of RF, UR, BR, or SL if serial polling loop

00PROG AS BR:3 A123-4567 3

TE CHNO L O GY TYP E

WIRE L E S S 0

Default ↑

In this example, the serial number is A123-4567. Once enrolled, the upper left-hand button of the program tool can be pressed to ready the system for enrolling a transmitter into the system.

The serial number for the program tool will only remain in the system until the programming mode is exited. (Entering ✱97 will not delete the tool.)

Press [✱] to continue.

Pressing the # key on the keypad will cause the system to back up to the "PROGRAM TOOL ?" prompt.

4.Enter the type of device(s) to be enrolled as follows:

0 = Wireless (Default)

1 = Polling Loop

2 = Both

Press [✱] to continue.

E NTE R ZN NO .		5. Enter the first zone number to be enrolled (e.g., zone 10).
(0 0 = Q UIT)	1 0	Press [✱] to continue.
		The system will, starting with this zone number, search for the first device
Zone Number Entered ↑
		which has all of the following attributes pre-programmed in Zone
		Programming:
		a ) An input type of RF, UR, BR, or SL (if serial polling loop
		devices enabled) programmed
		b ) A loop number programmed
		c ) No serial number programmed
		If the first zone number entered does not have one or more of the above
		attributes, the system will search its database for the first zone that does and
		will display it on the next screen.
		6. This prompt is displayed when the system has found the next zone which
10 INPUT S/N
		needs to be enrolled. The system will respond to the first serial number
Axxx xxxx
		transmitted after the [✱] key on the keypad or the button of the program
		tool is pressed. A single short beep will verify that the button has been
		pressed. A serial number may be enrolled by one of two methods:
		a) Enter the 7 digit serial number printed on the device.
		or
		b) Activate the device by faulting or restoring the input you wish to use for
		that zone (e.g., press a button, open or close a door, etc.).

Ð 5 Ð