Guardian Technologies VISTA-40 Connections diagram. Do not plug in at this time, Total, 13 Ð

Power-Up Procedure	1.	Fill out the Polling Loop Current Draw and Auxiliary Device Current Draw
		Worksheets shown below. Make sure that the currents drawn from these
		outputs do not exceed their respective ratings.
		CAUTION: Failure to observe the polling loop current rating will cause a
		polling loop malfunction. Failure to observe the auxiliary output current rating
		will result in a battery which does not charge properly, or possibly a tripped
		circuit breaker.
	2.	Wire the 1361 transformer (1361CN in Canada) to terminals 1 & 2 on the
		control panel (before connecting the battery), as shown in the SUMMARY OF
		CONNECTIONS diagram. Do not plug in at this time.
	3.	Connect all polling loop and auxiliary devices, such as keypads, PIRs, etc.
	4.	Plug the transformer into a 24-hour, uninterrupted AC outlet. After a few
		seconds, the green READY LED on the keypad(s) should light and the
		keypad(s) should display DISARMED READY TO ARM (Alpha keypads), or
		READY (Fixed-word keypads).
	5.	Connect the battery to the battery tabs on the control board using the battery
		cables supplied (use Red for + to +, Black for Ð to Ð). See the SUMMARY OF
		CONNECTIONS diagram.

POLLING LOOP CURRENT DRAW WORKSHEET

RPM DEVICE	CURRENT	# UNITS	TOTAL CURRENT
998MX PIR	1mA
4191SN Contact	1mA
4194 Contact	1 mA
4192SD Photo Smoke	0.4 mA
4192SDT Smoke w/Heat	0.4 mA
4192CP Ionization Detector	0.4 mA
4275 Dual Element PIR	1 mA
4278 Quad Element PIR	1 mA
4190WH 2-Zone RPM	1 mA (LOW)
	2 mA (HIGH)
4208 8-Zone RPM	16 mA
4278EX-SN PIR	1mA
4939SN Contact	1mA
4959SN Contact	1mA
		TOTAL CURRENT *

* If the total current draw exceeds 64 mA, a 4197 Loop Extender module must be used.

AUXILIARY DEVICE CURRENT DRAW WORKSHEET

DEVICE	CURRENT	# UNITS	TOTAL CURRENT
6128 Keypad	30mA
6137 Keypad	85mA
6139 Keypad	100mA
6139AV Keypad	200mA
675 Ground Start Module	50 mA
Built-in Polling Loop	(total poll loop worksht)
4281 RF Receiver	35mA
5881 RF Receiver	60mA
4197 Poll Loop Extender	80 mA
4204 Relay Module	15mA standby
	40mA per active relay
VIM Voice Interface Module.	80mA
*
*
	TOTAL	CURRENT (750mA max)

*If using hard-wire devices such as PIRs, refer to the specifications for that particular unit's current draw. Only applies if powered from Control's auxiliary power.

Ð 13 Ð