Guardian Technologies VISTA-40 Start Event Trouble Start ZN Type, RLY Voice DESCR? 0=NO 1=YES

Programming The Vim For	To program the system to trigger a relay upon an VIM fault, use the Relay
Relay Triggering On	Programming Menu (as described earlier) but enter the following values at the
Supervision Fault	appropriate prompts. When programmed, the relay activates upon VIM failure and
	deactivates when the operation of the VIM is restored.

0 2 START EVENT

TROUBLE 3

02 START: ZN TYPE

Enter 3 (trouble) as the event code to start the relay action.

Enter the start zone type code 64 (VIM Fail).

	Program the other Relay Programming prompts as you normally would.
Relay Voice Descriptors	For each of the 8 relays/X-10 modules used in the system, a voice descriptor can
	be programmed. This descriptor will be annunciated by the phone module when
	performing the #70 relay commands via telephone.
	Each voice descriptor can consist of up to 3 words selected from the relay voice
	descriptor vocabulary list shown below. Important: The index numbers from this
	vocabulary list are to be used for relay voice descriptors only. For normal system
	voice annunciation (e.g., alarms, troubles, status), use the highlighted words in
	the alpha vocabulary list found in the alpha programming section.

RLY VOICE DESCR? 0=NO 1=YES

Press 1 to program voice descriptors for relays.

ENTER RELAY NO.

00=QUIT 01

01 ENTER DESC	d1
01 ENTER DESC	d2
01 ENTER DESC	d3

Enter the 2-digit relay/X-10 module number (01-08) for the relay desired, or enter 00 to quit relay voice descriptor programming mode. Press [*] to accept entry.

From the relay voice descriptor vocabulary list, enter the 3-digit index number for the first word of the relay descriptor phrase. Press [*] to accept entry.

From the relay voice descriptor vocabulary list, enter the 3-digit index number for the second word of the relay descriptor phrase. If second word is not desired, press 000. Press [*] to accept entry.

From the relay voice descriptor vocabulary list, enter the 3-digit index number for the third word of the relay descriptor phrase. If third word is not desired, press 000. Press [*] to accept entry.

The ENTER RELAY NO. prompt will appear. Enter the next relay number to be programmed, or enter 00 to quit.

Ð 69 Ð