Guardian Technologies VISTA-40, N7001V2 Eee, Table of Contact ID Event Codes, 73 Ð

Contact ID Reporting	This is the only format that can identify all 64 protection zones by their unique
	zone (Contact) ID numbers, and provides a 1-digit event qualifier and 3-digit,
	specifically defined event code which quickly identifies the condition being
	reported.
	Contact ID reports in DTMF (Dual Tone Multi-Frequency @ 10 characters per
	second) and responds to a 1400 Hz followed by 2300 Hz handshake, and a 1400
	Hz kissoff. This format also uses checksum instead of two message verification. A
	complete report takes under 3 seconds.
	Contact ID Reporting takes the format: CCCC Q EEE GG ZZZ
	where:
	CCCC	=	Customer (subscriber) number.
	Q	=	Event qualifier, where: E=new event (1) and R= restore (3)
	EEE	=	Event code (3 hexadecimal digits), defined in the table below.
	GG	=	Partition number.

ZZZ= Zone/contact ID number reporting the alarm (001-099), or user number (001-099) for open/close reports. System status messages (AC Loss, Walk Test, etc.) contain zeroes in the ZZZ location.

TABLE OF CONTACT ID EVENT CODES

Code	Definition
110	Fire Alarm
121	Duress
122	Silent Panic
123	Audible Panic
131	Perimeter Burglary
132	Interior Burglary
133	24 Hour Burglary (zone type 11 if supported)
134	Entry/Exit Burglary
135	Day/Night Burglary
150	24 Hour Auxiliary
301	AC Loss
302	Low System Battery
305	System Reset
306	Program Tamper
309	Battery Test Fail
332	Poll Loop Short-Trouble
333	Addressable Device Failure
373	Fire Loop Trouble
380	Trouble (global)

ADVISORY:

Code	Definition
381	Loss of Supervision - RF
382	Loss of RPM Supervision
383	RPM Sensor Tamper
384	RF Transmitter Low Battery
401	O/C By User
403	Power-Up Armed
406	Cancel by User
407	Remote Arm/Disarm (Download)
408	Quick Arm
409	Keyswitch O/C
411	Call back Requested
441	Armed STAY
570	Bypass
602	Periodic Test
606	Audio Alarm Verificationto follow (AAVÐlisten-in)
607	Walk Test Mode, 2-Way Audio Test
621	Event Log Reset
625	Time/Date Reset
626	Time/date inaccurate

Ademco's new Contact ID reporting is capable of uniquely reporting all 64 zones of information, as well as openings and closings for all 70 users, to central stations equipped with the Ademco 685 receiver using software level 4.4 or higher. Must be level 4.6 to fully support all new VISTA-40 report codes. 685 software levels below 4.4 cannot support Contact ID reporting. For information regarding updating the 685 receiver, contact the Technical Support group (see CONTACTING TECHNICAL SUPPORT section toward the end of this manual).

NOTE: Contact ID event code Ò606Ó is sent only if a VIM, and at least one 2-way voice keypad is used, and the AUTO CALLBACK option is disabled. If AUTO CALLBACK option is enabled, then the restriction that the 685 Rev number must be 4.6 or higher no longer applies, and the 2-way voice feature will work with ANY central station receiver.

Ð 73 Ð