Guardian Technologies VISTA-40, N7001V2 installation instructions 99 Ð

SCAN LOG BY PART	The system allows viewing of any partition's event log.
0=NO 1-2=PART #	Enter the partition number for the partition whose events
	are to be displayed. Entering 0 (NO) will display all events
	that occurred in the system regardless of partition.
	For display purposes, events are stored on a partition by
	partition basis (except system events), and are grouped
	into five categories as follows.

Use the [3] & [1] keys to scroll to the next or previous category screens respectively:

ALARM EVENT LOG TYPE CCC UUU

CHECK EVENT LOG TYPE CCC UUU

BYPASS EVENT LOG

TYPE CCC UUU

OP/CL EVENT LOG TYPE CCC UUU

Displays time/date for zones that have either caused an alarm or have been restored in selected partition.

Displays time/date for zones that have caused a trouble or supervisory condition in selected partition.

Displays time/date for zones that have been bypassed in selected partition.

Displays time, date and user number for each arming and disarming of the system for the partition selected. Note that only those users enabled by the installer during "add a user" procedure will be logged.

SYSTEM EVENT LOG

TYPE CCC UUU

ALL EVENT LOG TYPE CCC UUU

Displays time/date for system problems, such as AC Loss, communication failure, etc., regardless of partition.

Displays all categories of events in chronological order, from most recent to oldest.

To display the events in a particular category, press [8] at the desired category screen.

If in Display Mode, events will appear one at a time from the most recent to the oldest. Use the [1] key to display events backward in time (from recent to past). Use the [3] key to display events forward in time. The following is a typical display:

P2 01/01 12:02AM

BURGLARY C03

Shows burglary alarm occurred in zone 3 of partition 2, at 12:02AM on January 1.

After the last event in the selected category has been displayed, the system will automatically return to the next event category screen.

Clear Event Log To clear the Event Log, enter installer code + [#] + [6] + [2]

The following will appear:

CLEAR EVENT LOG 0=NO 1=YES

Press [1] if Event Log is to be cleared from memory. All events in the log will still be displayed if the COMPLETE option is selected. Only those events occurring from the time of the CLEAR command will be displayed if RECENT display option is selected. Press [0] if event log is not to be cleared at this time.

If [1] is pressed, the following will appear:

ARE YOU SURE? 0=NO 1=YES

Press [1] if it is desired to clear the event log. Press [0] if event log is not to be cleared.

Screen Definitions
	RECENT	Events since last CLEAR
	COMPLETE	Displays all events
	TYPE	Type of event (Burg., Fire, etc.)
	CCC	Zone (contact) number
	UUU	User number

Ð 99 Ð