Guardian Technologies N7001V2 Event Logging, Operator Commands, Key Function Comments, = Complete

Note: If the operator makes a mistake in entering the proper 4-digit ID code, the operator just needs to re-enter the correct code. If after 5 minutes have elapsed without the central station callback, only a new alarm will initiate a new 2-way voice session.

Operator Commands The following table summarizes the central station operator commands available. To perform a command, the operator simply presses the appropriate telephone key(s).

	OPERATOR	COMMANDS
Key	Function	Comments
1	Talk Mode	Operator can speak to persons on
	(1 beep)	premises.
2	VOX Mode (2-way voice)	Operator can both speak and listen
	(2 beeps)	to persons on premises.
3	Listen Mode	Operator can listen to activity at the
	(3 beeps)	premises. Repeated depressions of
		"3" toggle keypad listening levels from
		high to medium to low to high, etc.
4	Select Next Keypad	The first keypad is keypad #1.
5	Select Keypad #2
6	Select Keypad #3
7	Extend timeout 90 secs	This allows more time for the operator
		to begin a session.
8 8	Disconnect with callback	The operator can choose to discon-
		nect the session, but call back within 5
		minutes.
9 9	Disconnect	This command terminates a session.
0	Return to Listen to All Mode
* 8 n n	Select Keypad nn	Use this command to select any
	(keypad No. 01-15)	keypad. e.g. *803 selects keypad #3.
#	Reset and select Keypad #1	Returns session to Listen Mode

EVENT LOGGING

Event Logging Procedures

Programming

Event Logging Display

Ð 98 Ð

IMPORTANT: In order for time and date stamping to occur, the system's real-time clock must be set. Refer to the SETTING THE REAL TIME CLOCK section.

The system has the ability to record various events in a history log (100 event capacity) wherein each event is recorded in one of five categories (alarm, check, bypass, open & system), with the time and date of its occurrence (if real-time clock is set). The log may be viewed (Display Mode) using an alpha keypad.

NOTE: The VISTA-40 does not support event log printing.

EVENT LOG MODE COMMANDS
Display Mode (installer or	master):	Enter CODE + [#] + [6] + [0]
Clear Event Log (installer	only):	Enter CODE + [#] + [6] + [2]
To EXIT Event Log Mode:		Press [*] at any time.

The system can be configured for the following event log activities:

¥Specific categories of events can be selectively enabled (field 1*70).

¥The time stamp can be set for either 12 or 24 hour formats (field 1*71).

¥Set event log time/date report enable (fields 1*40 & 1*41).

After entering event log mode, the following will be displayed:

ENTER 0 = RECENT	The Event Log holds up to 100 events, and can display
1 = COMPLETE	all events in a category (complete), or only those events
	in a category occurring since the last Clear Event Log
	command (recent). Note that once the Event Log is full,
	the oldest event will be erased upon logging of any new
	event. Press the desired display mode key, 0 or 1.