Guardian Technologies N7001V2, VISTA-40 installation instructions 92 Ð

To ADD a Master, Manager or Operator code

Installer must program at least one Master c o d e .

Important!: During user code entry, normal key depressions at other keypads in a partition will be ignored. However, panic key depression will cause an alarm and terminate user entry.

Note: User codes cannot be added by using the Phone Module. User codes must be added by using an alpha keypad only.

Enter Installer Code + [8] + new User # (02-69) + new User's code Keypad will prompt for the Authority Level for this user.

Or Master or Manager code, but must be code with higher level of authority than the code being changed. (i.e. Master code can add a Manager or Operator level code, but cannot add another Master code; a Manager code can add an Operator level code, but cannot add a Master or another Manager code).

User Number = 03 Enter Auth.Level

Enter the level number as follows:

1 = Master (Arm, Disarm, Bypass, add or modify lower level users)

2 = Manager (Arm, Disarm, Bypass, add or modify lower level users)

3 = Operator Level A (Arm, Disarm, Bypass)

4 = Operator Level B ( Arm, Disarm)

5 = Operator Level C ( Arm, Disarm only if system armed with this code)

6 = Duress (Arm, Disarm, triggers silent panic alarm)

Open/Close Rep.? 0 = NO , 1 = YES

RF Button ? 0=NO , 1=YES

Enter Button ZN # (01-63)

Multi-Access ?

0 = NO , 1 = YES

Global Arm ?

0 = NO , 1 = YES

Keypad will then prompt for Open/Close reporting option for this user.

Press 0 (NO) or 1 (YES), depending on whether or not arming/disarming by this user will trigger opening

&closing reports. This prompt appears only if the installer code is used to add a user.

If a 5800 series button transmitter has been enabled, and not assigned to a user, this prompt will appear.

If yes was given as the answer to the RF button question, the zone number for the button will be requested. Enter one of the zone numbers assigned to the button transmitter as AWAY, STAY or DISARM. The system will then assign any STAY, AWAY or DISARM buttons of the transmitter to this user number.

Press 0 (NO) or 1 (YES). If NO, the program exits this mode. If yes, the Keypad prompts for the Global Arm option for this user.

Press 0 (NO) or 1 (YES), depending on whether or not this user will be allowed to arm more than one partition via Global Arm prompts (described in the KEYPAD FUNCTIONS section) .

If the Multi-Access option was selected for this user, the keypad now prompts for the userÕs access to the next partition.

Ð 92 Ð