Guardian Technologies VISTA-40, N7001V2 That you confirm the programming of every device before

10 LOOP #

1

10.The cursor should now be flashing on the loop number. The default is "1." To accept this, press [✱]. If a different loop number is being used on this device, enter the loop number (1-4) and press [✱] to continue (see the loop designations for various RF transmitters on page 8 of this addendum). The loop number must be entered here, whether using Zone Programming or Sequential Mode to "enroll" serial numbers. If you want to delete the serial number, enter "0" and press [✱]. The system will then prompt, "DELETE S/N?" Press the "1" (YES) key to complete the delete sequence. This process deletes the serial number only, not the loop number. The assumption is that the proper loop number was programmed, but the wrong serial number was enrolled.

10 LEARN S/N?

1 = YES, 0 = NO 1

11.If the device’s serial number has not been previously “enrolled,” you may enter the enrollment mode now by either entering "1" (YES) or by pressing the upper left-hand button of the program tool. If using the program tool, move to the physical location of the device to be enrolled before pressing the button. A single short beep will verify that the button has been pressed. The system will respond to the first serial number transmitted after the [1] key on the keypad or the button of the program tool is pressed. Enter "0" (NO) to enroll later. (If "0" is entered, go to step 14.)

10 INPUT S/N		12. This prompt is displayed if "1" (YES) is entered in response to the "Learn
		S/N?" prompt. The serial number may be enrolled by one of two
Axxx-xxxx
		methods:
		a) Enter the 7-digit serial number printed on the transmitter using an alpha
		keypad
		or
		b) Activate the device by faulting or restoring the input you wish to use
		for that zone (e.g., press a button, open or close a door, etc.).
		The system will enroll the serial number of the first device heard.
10 INPUT S/N
A022-4064
		If the serial and loop number combination is already present in the system,
		the keypad will sound a single long beep and display the word "DUPLICATE"
		along with the serial number, and the number of the zone containing the
		serial/loop number combination.
		13. The system will then enter an optional confirmation mode so that the
		operation of the actual programmed input can be confirmed. Activate the
		loop input or button that corresponds to this zone. We recommend
		that you confirm the programming of every device before
		proceeding to the next zone.
		When the system sees activity on the appropriate input, it will beep three
10 CONFIRM RF:1
		times and display the confirmation message.
A022-4064	1

Ð 3 Ð