Guardian Technologies N7001V2, VISTA-40 Remote Keypad Sounding Connections, 30 Ð

Remote Keypad Sounder	An optional Amseco PAL 328N can be used for installations where it is desired to
Operation & Wiring	remote the sounds produced by the keypad's built-in piezo sounder for one
	partition. The panel will remote all sounds (i.e. alarm, trouble, chime, entry/exit,
	etc.) produced by the keypad's built-in sounder except for the short clicks
	associated with keypad key depression. One application of this feature might be
	to produce chime sounds in a location which is distant from the panel's keypads.
	This can also be accomplished using relay outputs (see Output Relay section).
	If used, program field 1*46 must be set to "2" to enable the remote keypad
	sounder option, and the Amseco piezo must be connected between the panel's
	auxiliary power and the J7 connector trigger output as shown below.
	In addition, field *15 must be used to select the partition whose keypad sounds
	are to trigger the sounder. Zone 7 must be assigned to be a keyswitch zone
	(even if keyswitch is not used).

IF USED.

4142TR CABLE J7 CONNECTOR

1.OUT 1 IS NO LONGER USABLE FOR OPEN/CLOSE OR GROUND START (SEE FIELD 1*46).

2.OUT 2, 3, 4 CAN STILL BE USED TO PROVIDE ALARM STATUS INDICATIONS OR TO OPERATE A KEYSWITCH (SEE FIELD *15).

TO AUX POWER +

TERMINAL 6RED (10mA CURRENT DRAW)

BLACK

–

AMSECO PAL-328N

PIEZO SOUNDER

+

GROUND OUT 1

GROUND OUT 2

GROUND OUT 3

GROUND OUT 4

GRAY

YELLOW

WHITE

RED

GREEN

BROWN

BLUE

BLACK

N/U	1
	2
	3
	4
	5
	6
	7
	8
	9

REMOTE KEYPAD SOUNDING CONNECTIONS

Using A Trigger To If using an Audio Alarm Verification module from another manufacturer, and a Activate Another voltage trigger will be used to activate the module, make connections as shown ManufacturerÕs AAV below. In addition, set program field 1*46 to option 3, and program zone 5 for

Unit (if necessary) response type 10; also, program field 1*60 for Ò1Ó.

Note: If field 1*60 is set for Ò1Ó, zone 5 cannot be used as a protection zone, and the EOLR must be removed. Refer to the 2-WAY VOICE KEYPADS & AUDIO ALARM VERIFICATION section later in this manual for additional information.

4142TR CABLE J7 CONNECTOR

TO AUDIO ALARM

VERIFICATION MODULE

(AAV) FALLING EDGE
TRIGGER INPUT
ON THE AAV UNIT	DIODE INCLUDED
	WITH EOLR
	PACKAGE

GROUND OUT 1

GROUND OUT 2

GROUND OUT 3

GROUND OUT 4

GRAY

YELLOW

WHITE

RED

GREEN

BROWN

BLUE

BLACK

N/U	1
	2
	3
	4
	5
	6
	7
	8
	9

USING A TRIGGER TO ACTIVATE A NON-ADEMCO AAV UNIT

Ð 30 Ð