Message | Description |
| |
|
| ||
Subnet Mask | The IP subnet mask configured on the print server. During initialization, a | ||
| temporary value 0.0.0.0 is displayed. Depending on configuration | ||
| parameters, the print server may automatically assign a usable default | ||
| value. |
| |
| ● | Not Specified | a subnet mask is not configured. |
|
| ||
Default Gateway | The IP address of the gateway used when sending packets off the local | ||
| network. Only one default gateway may be configured. During initialization, | ||
| a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the | ||
| print server is used. |
| |
| ● | Not Specified | a default gateway is not configured. |
|
| ||
Config By | Identifies how the print server obtained its IP configuration. | ||
| ● | BOOTP automatic configuration via a BOOTP server. | |
| ● | BOOTP/TFTP automatic configuration via a BOOTP server and TFTP | |
|
| configuration file. |
|
| ● | DHCP automatic configuration via a DHCP server. | |
| ● | DHCP/TFTP automatic configuration via a DHCP server and TFTP | |
|
| configuration file. |
|
| ● | RARP automatic configuration via the Reverse Address Resolution | |
|
| Protocol. |
|
| ● | User Specified | manual configuration via Telnet, the printer’s |
|
| control panel, HP Web JetAdmin, embedded web server, or other | |
|
| method. |
|
| ● | Default IP the default IP address was assigned. This address may | |
|
| not be a valid address for your network. | |
| ● | Not Configured | the print server was not configured with IP |
|
| parameters. Verify that TCP/IP is enabled, or check for error status. | |
|
| ||
BOOTP Server | Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It | ||
or | specifies the IP address of the system that responds to the print server’s | ||
DHCP Server | request for automatic TCP/IP configuration over the network. | ||
or | ● | Not Specified | the configuration server’s IP address could not be |
RARP Server |
| determined or was set to zero in the response packet. | |
|
| ||
BOOTP/DHCP Server | Displayed during initialization while the print server attempts to obtain its | ||
| TCP/IP configuration from a BOOTP or DHCP server. The temporary | ||
| address displayed is 0.0.0.0. | ||
| ● | Not Specified | the configuration server’s IP address could not be |
|
| determined or was set to zero in the response packet. | |
|
| ||
TFTP Server | The IP address of the system where the TFTP configuration file is located. | ||
| During initialization, the temporary address 0.0.0.0 is displayed. | ||
| ● | Not Specified | a TFTP server has not been set. |
|
| ||
Config File | The name of the print server's configuration file. The file pathname may be | ||
| truncated to fit on two lines. | ||
| ● | Not Specified | a file was not specified in the BOOTP reply from the |
|
| host. |
|
EN | Interpreting the configuration page 201 |
