HP 3300mfp manual Error messages, Error Code and Message Description

Error messages

Error Code and Message	Description
02	During self-test, the print server detected an internal loopback test error.
LAN ERROR- INTERNAL	The print server may be faulty. If the error persists, replace the print server.
LOOPBACK
03	The print server is incorrectly connected to your network or is defective.
LAN ERROR- EXTERNAL	Make sure your print server is correctly attached to your network. In
LOOPBACK	addition, check the cabling and connectors.
07	Check the network connections. If the connections are intact, run the
LAN ERROR- CONTROLLER	power-on self-test: turn the printer off, then on again. If the error persists,
CHIP	replace the print server.
08	There is a network congestion problem.
LAN ERROR- INFINITE	Note: If the print server is not connected to the network, this error cannot
DEFERRAL
	occur.
09	Check the network connections. If the connections are intact, run the
LAN ERROR- BABBLE	power-on self-test: turn the printer off, then on again. If the error persists,
	replace the print server.
0A	Check the network connections. If the connections are intact, run the
LAN ERROR- NOSQE	power-on self-test: turn the printer off, then on again. If the error persists,
	replace the print server.
0C	There may be a problem with your network cabling or the print server.
LAN ERROR- RECEIVER	Check the cabling and connectors on your Ethernet network. If you cannot
OFF	find a problem with your network cabling, run the power-on self-test:
	remove and re-attach the power module connector on the print server. If the
	error persists, there is a problem with the print server.
0D	There may be a problem with your network cabling or the print server.
LAN ERROR- TRANSMITTER	Check the cabling and connectors on your Ethernet network. If you cannot
OFF	find a problem with your network cabling, run the power-on self-test:
	remove and re-attach the power module connector on the print server. If the
	error persists, there is a problem with the print server.
0E	Check the network connections. If the connections are intact, run the
LAN ERROR- LOSS OF	power-on self-test: remove and re-attach the power module connector on
CARRIER	the print server. If the error persists, replace the print server.
10	There may be a problem with your network cabling or the print server.
LAN ERROR- UNDERFLOW	Check the cabling and connectors on your network. If you cannot find a
	problem with your network cabling, run the power-on self-test: remove and
	re-attach the power module connector on the print server. If the error
	persists, there is a problem with the print server.
11	There is a problem with your network cabling or external network
LAN ERROR- RETRY	configuration. Verify operation of the hub or switch port.
FAULTS

206 16 Troubleshooting network problems EN