HP 3300mfp manual Was not the BOOTP/DHCP server port 67/udp

Error Code and Message	Description
52	An error was detected in the BOOTP or DHCP reply that the print server
BAD BOOTP/DHCP REPLY	received. The reply either had insufficient data in the UDP datagram to
	contain the minimum BOOTP/DHCP header of 236 bytes, had an operation
	field that was not BOOTPREPLY(0X02), had a header field that did not
	match the print server’s hardware address, or had a UDP source port that
	was not the BOOTP/DHCP server port (67/udp).
53	The tagsize in a vendor-specific field in the BOOTP reply is either 0, or
BAD BOOTP TAG SIZE	greater than the remaining number of unprocessed bytes in the
	vendor-specified area.
54	The print server is currently in the process of obtaining its basic IP
BOOTP/RARP IN PROGRESS	configuration information through BOOTP/RARP.
55	The print server is currently in the process of obtaining its basic IP
BOOTP/DHCP IN PROGRESS	configuration information through BOOTP/DHCP, and has not detected any
	errors.
56	The print server received a negative acknowledgment message from the
DHCP NAK	DHCP server in response to a configuration request.
57	The print server had received IP parameters from a DHCP server, but
UNABLE TO CONNECT DHCP	communication with the DHCP server has been lost. Check status of the
SVR	DHCP server.
	If an infinite lease was assigned, the print server will use the IP address of
	the most recent DHCP server used, but operation may be degraded until a
	DHCP server responds.
58	The printer does not support AppleTalk or AppleTalk extensions.
POSTSCRIPT MODE NOT
SELECTED
59	Firmware download message. Currently downloading firmware to the print
INCOMPLETE F/W - MUST	server, or the download did not complete properly.
DOWNLOAD
5A	Firmware download message. Download of firmware is complete. Power
TURN PRINTER OFF/ON	cycle the print server.

83DISCONNECTING FROM The server has been shut down because of a configuration change or reset

SERVER	request. This message automatically clears after a few seconds, unless the
	printer is off line, is in an error state, or is servicing another I/O port or
	another network protocol.
F1	The print server is trying to connect to the NetWare server(s). This is a
TRYING TO CONNECT TO	normal message. Wait until either the connection is established or another
SERVER	status message appears.

EN Interpreting the configuration page 213