Note | The default set at the factory for stamp received faxes is Off. |
Setting the fax error correction
Normally, the product monitors the signals on the telephone line while it is sending or receiving a fax. If the product detects an error signal during the transmission and the error correction setting is on, the product can request that a portion of the fax be resent.
You should only turn error correction off if you are having trouble sending or receiving a fax, and you want to accept the errors in the transmission. Turning the setting off might be useful when you are trying to send or receive a fax overseas, or if you are using a satellite telephone connection.
To change the error correction setting
1Press menu/enter.
2Use the < and > buttons to select Fax Setup and press menu/enter.
3Use the < and > buttons to select All Faxes and press menu/enter.
4Use the < and > buttons to select Error Correction and press menu/enter.
5Use the < and > buttons to select On or Off and press menu/enter to save your selection.
Note | The default set at the factory for error correction is On. |
Selecting tone- or
Use this procedure to set the product to tone- or
To select tone- or
1Press menu/enter.
2Use the < or > button to select Fax Setup and press menu/enter.
3Press > once to select Fax Send Setup and press menu/enter.
4Use the < or > button to select Dialing Mode and press menu/enter.
5Use the < or > button to select Tone or Pulse and press menu/enter to save your selection.
Changing redial settings
If the product was unable to send a fax because the receiving fax machine did not answer or was busy, the product will attempt to redial based on the redial on busy and redial on no answer options. Use the procedures in this section to turn these options on or off.
Note | The product will, by default, redial if the receiving fax machine is busy but will not, by default, redial |
| if the receiving fax machine does not answer. |
|
|
EN | Setting the fax error correction 99 |