Installing the ADF input tray
If your HP LaserJet 3300 series product comes with an ADF, or if you purchased the HP LaserJet
3300 series ADF accessory, use the following instructions to install the ADF input tray:
1Align the two tabs on the input tray with the two grooves in the ADF lid.
2Slide the tray into the grooves as shown until the tray snaps into place.
Connecting the power cord
To connect your product to a power source, use the following steps.
1If you have the 220V product, locate the power switch on the back of the product and make sure the product is switched off.
2Connect the power cord to the product, as shown (1).
3Plug the other end of the power cord directly into a grounded AC outlet (2).
1
2
4If you have the 220V product, switch on the power. If you have the 110V product, there is no power switch. It will automatically power on when it is plugged in.
Note | HP does not recommend the use of uninterrupted power supply (UPS) battery backup devices or |
| surge suppressors with this product. Many surge suppressors and battery backups can cause print |
| defects. |
|
|
30 2 Getting started | EN |