HP 4100N Disk File, Operation Failed, System is Full, Disk is, Write Protected, Initializing

Printer messages (continued)

Message	Explanation or recommended action
DISK FILE	The requested operation could not be performed. You might have
OPERATION FAILED	attempted an illegal operation, such as trying to download a file to a
	non-existent directory.
DISK FILE	Delete files from the EIO disk and then try again. Use HP Resource
SYSTEM IS FULL	Manager to download or delete files and fonts. (See the software help
	for more information.)
DISK IS	The EIO disk is protected, and no new files can be written to it.
WRITE PROTECTED	Disable the write protection through HP Resource Manager.
EIO [n] DISK	The disk accessory in EIO slot [n] is initializing.
INITIALIZING
EIO [n] DISK	The EIO disk is not working correctly.
NOT FUNCTIONAL	Remove the EIO disk from the slot indicated by [n].
	Replace it with a new EIO disk.
EIO [n]	Wait for the message to disappear (up to 5 minutes). If the printer EIO
INITIALIZING	card is operating correctly and communicating with the network, this
alternates with	message disappears after approximately 1 minute and no action is
	required.
DO NOT POWER OFF	If the EIO card is unable to communicate with the network, this
	message remains for 5 minutes and then disappears. In this case the
	printer is not communicating with the network (even though the
	message is no longer present). The problem may be a bad EIO card,
	a bad cable or connection on the network, or a network problem.
	Contact your network administrator.
EIO [n] DISK	The disk accessory in EIO slot [n] is initializing.
SPINNING UP
ENV FEEDER LOAD	A job has been sent to the envelope feeder and it is empty.
[TYPE] [SIZE]	Load the correct size and type in the feeder. Pressing GO will prompt
	a question asking if you would rather print on another available size
	of envelope in the printer. Press -VALUE+to scroll through the
	available types and sizes; press SELECT to accept an alternate type
	or size.
	Make sure the envelope size and type are set correctly from the Paper
	Handling Menu in the printer control panel (see “Paper Handling
	Menu” on page 210).

EN Understanding printer messages 113