Printing transparencies
Use only transparencies recommended for use in laser printers. For transparency specifications, see “Transparencies” on page 196
●Load transparencies face up in tray 1 with the top toward the printer. Up to 50 transparencies can be loaded in tray 1.
●A stack of 50 to 100 transparencies can be printed from tray 2, 3, or 4 (although stacking more than 50 at a time is not recommended). Because transparencies are heavier than paper, do not load tray 2, 3, or 4 to capacity. Load them with the
●To prevent transparencies from becoming too hot or sticking together, use the top output bin.
●Remove each transparency from the output bin before printing another.
●Do not feed transparencies through the printer more than once.
●Print only on one side of a transparency.
●Place transparencies on a flat surface to cool after removing them from the printer.
●Select the transparency paper type from the printer driver so that the printer uses the low fuser mode that is best for printing them.
●If two or more transparencies feed at the same time, try fanning the stack.
62 Chapter 2 - Printing tasks | EN |