HP 4100N, 4100TN Parallel I/O, Transmission, Paper Size, Expected, Printer Error, Cycle Power to

Printer messages (continued)

Message	Explanation or recommended action
22 PARALLEL I/O	Too much data was sent to the parallel port.
BUFFER OVERFLOW	Check for a loose cable connection and be sure to use a high-quality
alternates with	cable (see “Ordering information” on page 22). (Some non-HP
	parallel cables might be missing pin connections or might otherwise
PRESS GO TO
	not conform to the IEEE-1284 specification.)
CONTINUE	This error can occur if the driver you are using is not IEEE-1284
	compliant. For best results, use an HP driver that came with the printer
	(see “Printer drivers” on page 35).
	Press GO to clear the error message. (Data will be lost.)
40 EIO [x] BAD	The connection has been broken between the printer and the EIO
TRANSMISSION	card in the specified slot. (Data loss might occur in this situation.)
alternates with	Press GO to clear the error message and continue printing.
PRESS GO TO
CONTINUE

41.3UNEXPECTED The printer detected a paper size different than what it was expecting.

PAPER SIZE	This is typically caused if two or more sheets stick together in the
alternates with	printer or if the paper tray is not properly adjusted.
	Reload the tray with the correct paper size.
EXPECTED
[TYPE] [SIZE]	Ensure that paper in the tray is loaded under the front and back tabs.
	If you are printing from tray 1, verify that the correct paper size is
	selected in the control panel (see “Paper Handling Menu” on
	page 210).
	If you are printing from tray 2, 3, or 4, verify that the three paper size
	adjustments on the paper tray have been made correctly (see the
	description of adjustments in “Loading trays 2, 3, and 4” on page 47).
	After performing the actions above, press GO. The page containing
	the error will automatically be reprinted if jam recovery is enabled.
	(Or, you might want to press CANCEL JOB to clear the job from the
	printer’s memory.)
41.x	A temporary printing error occurred.
PRINTER ERROR	Press GO. The page containing the error will automatically be
alternates with	reprinted if jam recovery is enabled.
	If the error does not clear, turn the printer off, then turn the printer on.
CYCLE POWER TO
CONTINUE

49.xx

PRINTER ERROR

alternates with

CYCLE POWER TO CONTINUE

A temporary printing error occurred.

Press GO. The page containing the error will automatically be reprinted if jam recovery is enabled.

If the error does not clear, turn the printer off, then turn the printer on.

EN Understanding printer messages 121