HP 5SI manual Mopier Messages, Message Description Recommended Action

Mopier Messages

Table 7-2 lists and describes mopier messages and suggests recommended actions.

Table 7-2	Mopier Messages
Message		Description	Recommended Action
READY		The default ready message. The	No action required.
		mopier is ready to use.
OFFLINE		The mopier is offline and cannot	Press [On[Line].
		print data.
WARMING UP		The mopier is warming up and is	Wait until the mopier signals
		not ready to accept data.	READY.
POWER SAVE ON		The mopier is in Power Save	No action required. The job
		mode. In Power Save mode all	prints when the fuser has
		control panel keys operate	warmed (about 45 seconds).
		normally. (See “Configuration
		Menu” in Chapter 4.)
PERFORM USER		This message indicates that the	Purchase a maintenance kit
MAINTENANCE		mopier requires routine	and install the new parts. Then
		maintenance. It will replace the	remove the message by
		READY message until it is cleared.	turning SERVICE MESSAGE=
			OFF in the CONFIGURATION
			MENU.
PRINTING		The mopier is printing a	No action required.
CONFIGURATION PAGE		configuration page.
PRINTING FONT LIST		The mopier is printing a font list.	No action required.
		(Note that PCL/PostScript formats
		are the same.)
PRINTING DEMO PAGE		The mopier is printing a	No action required.
		Demonstration Page.
MOPY XX OF YY from		This message indicates the	No action required.
Tray n		progress of the current job.
INTERNAL TEST		The mopier is conducting a test of	No action required.
		its components.
PROCESSING JOB FROM		The mopier is working on a job	No action required.
TRAY n		from the indicated tray.
TRAY n LIFTING		The mopier is lifting the paper tray	No action required.
		to its working position after paper
		was loaded.

Continued on the next page.

7 Maintenance & Troubleshooting

EN Maintenance and Troubleshooting 7-35