HP 5SI manual Memory and Personality Simm Installation C-3

4
5		20
1	2	3
		4
6		45
1	2	3
		4
7		B
		A

4Remove the SIMM board from the antistatic package. Do not touch any component on the SIMM board. Hold the board with your forefingers on the side edges and your thumbs against the back edge, so the notch on one end is on the right and the metal teeth face toward the SIMM slot.

5Insert the board firmly into the SIMM slot (5) at about a 20-degree angle. Use the closest open slot, starting with 4 as illustrated.

6Rotate the SIMM toward the back of the printer to about a 45-degree angle until it clicks into the metal locking tabs. If it is properly seated, it will not lift away from the slot. (To remove a SIMM, you must first release the metal locking tabs.)

7Align the printer formatter board with the top slot, slide the board back into the printer (A), and tighten the two screws (B).

8Re-attach any cables and the power cord; then switch the printer power ON and test the SIMM (see the following section).

Memory/ C Personality SIMM

EN

Memory and Personality SIMM Installation C-3