HP 5SI manual Mopier encountered a parity Switch the mopier OFF

Table 7-2	Mopier Messages, continued
If the following errors persist, call your HP-authorized service provider.
Message		Description		Recommended Action
61.x PRINTER ERROR		The mopier encountered a parity		Switch the mopier OFF and
CYCLE POWER		error when accessing internal		then ON (data stored in
		RAM or some SIMM memory in		mopier will be lost). If the
		slot x.		error is still present, first
		0:	Internal memory	verify that the SIMM board is
				correctly installed. Switch the
		1:	SIMM slot 1
				mopier ON. If the error is still
		2:	SIMM slot 2
				present, switch the mopier
		3:	SIMM slot 3
				OFF and remove the SIMM
		4:	SIMM slot 4
				board. Switch the mopier
				back ON. If the error
				message does not appear,
				the problem is on the SIMM.
				See Appendix C, “Memory
				and Personality SIMM
				Installation,” for more
				information.
62.x PRINTER ERROR		The mopier identified a CRC error		Switch the mopier OFF and
CYCLE POWER		while checking its memory. x		then ON (data stored in
		refers to the memory the mopier		mopier will be lost). If the
		was checking when it encountered		error is still present, first
		the error.		verify that the SIMM board is
		0:	Internal memory	correctly installed. Switch the
				mopier ON. If the error is still
		1:	SIMM slot 1
				present, switch the mopier
		2:	SIMM slot 2
				OFF and remove the SIMM
		3:	SIMM slot 3
				board. Switch the mopier
		4:	SIMM slot 4
				back ON. If the error
				message does not appear,
				the problem is on the SIMM.
				See Appendix C, “Memory
				and Personality SIMM
				Installation,” for more
				information.
64 PRINTER ERROR		The mopier identified a scan		Turn the mopier OFF then
CYCLE POWER		buffer error.		ON again.
65 PRINTER ERROR		The mopier identified a dynamic		Turn the mopier OFF then
CYCLE POWER		RAM controller error.		ON again.

Continued on the next page.

7-44 Maintenance and Troubleshooting

EN