HP 5SI manual Device 1-5 and yy is the error

Table 7-2	Mopier Messages, continued
If the following errors persist, call your HP-authorized service provider.
Message		Description		Recommended Action
66.x.yy DEVICE ERROR		The mopier identified a paper		Turn the mopier OFF then ON
CYCLE POWER		handling controller error. x identifies		again.
		the device (1–5) and yy is the error
		code (0–99)
		0:	Paper Handling
			Controller (PHC)
		1:	First device attached
			to the PHC
		2:	Second device
			attached to the PHC
		3:	Third device attached
			to the PHC
		4:	Fourth device attached
			to the PHC
		5:	Fifth device attached to
			the PHC
67 PRINTER ERROR		The mopier identified a		Turn the mopier OFF then ON
		miscellaneous interface hardware		again.
		error.
68 ERROR		There is a checksum error in the		Check all menu settings; reset
CHECK CONFIGURATION		mopier’s nonvolatile memory		if necessary. Press [Select[*]
		(NVRAM). Some or all of the menu		to continue. If you switch the
		items have been reset to the		mopier OFF and then ON, you
		factory default values.		may lose settings (to check
				settings, print a configuration
				page).
68 NVRAM FULL		The mopier’s nonvolatile memory		Press [Select]*] to continue.
CHECK CONFIGURATION		(NVRAM) is full.		The system will automatically
				perform a cold reset and
				display RESTORING FACTORY
				SETTINGS. The system will
				complete initialization and
				return to the online condition.

7 Maintenance & Troubleshooting

Continued on the next page.

EN Maintenance and Troubleshooting 7-45