HP 5SI manual Firmware Simm problem was Switch the mopier OFF

Table 7-2	Mopier Messages, continued
If the following errors persist, call your HP-authorized service provider.
Message		Description	Recommended Action
70 ERROR or 71 ERROR		A firmware SIMM problem was	Switch the mopier OFF and
CHECK CONFIGURATION		identified (incompatibility between	then back ON.
		SIMM/hardware/BIOS).
79 SERVICE (xxxx)		An internal controller error	Switch the mopier OFF and
CALL SERVICE		occurred. xxxx indicates the error	then back ON. If the error
		type.	appears again, turn power
			OFF and remove any non-HP
			SIMM memory boards from
			the mopier. Then switch the
			mopier back ON. If the error
			appears again, record the
			numbers following the error
			message and call your
			authorized HP dealer or
			service representative.
80 SERVICE (xxxx)		The mopier detected a problem in	Switch the mopier OFF and
CALL SERVICE		the MIO card. xxxx indicates the	then back ON. If the error
		error type.	appears again, record the
			numbers following the error
			message and call your card
			supplier, or authorized HP
			dealer or service
			representative.

Continued on the next page.

7-46 Maintenance and Troubleshooting

EN