HP 5SI manual Print Quality Menu

Print Quality Menu

The Print Quality Menu allows you to change the physical characteristics of the printed page. All choices are saved until the current print job has ended, except for Print Density, which changes after a few pages. See Chapter 6, “Print Quality,” for more information.

Table 4-10 presents the messages that appear when you select each of the menu items.

Table 4-10	Print Quality Menu
Menu		Item	Explanation
PRINT QUALITY		ECONOMODE=	Reduces the amount of toner on the printed page;
MENU		[OFF*, ON]	the result is similar to draft mode on some dot
			matrix printers. (See Chapter 6.)
		RESOLUTION=	Prints at 300 or 600 dpi. If the mopier is unable to
		(600*,300) DOTS	print a job at 600 dpi, the mopier reverts to 300 dpi
		PER INCH	for the remainder of the job.
		RESOLUTION	Prints fine quality characters and graphics by
		ENHANCEMENT=	smoothing the fine gradations along the angles
		[OFF,ON*]	and curves of the printed image.
		PRINT DENSITY=	Varies the amount of toner applied to the paper
		[1,2,3*,4,5]	while printing. The higher the setting (5 is highest)
			the darker the page; the lower the setting (1 is
			lowest) the lighter the page.
			Changes to this setting are effective during a
			printed job by stopping the receipt of new data,
			clearing the mopier of pages, changing the density,
			and then resuming the print job.
* Factory default

4-26 Mopier Control Panel

EN