HP 5SI manual Input/Output IO Menu, Menus Explanation

Input/Output (IO) Menu

This menu contains the items related to I/O buffering. See Chapter 2, “Memory and Memory Management,” for additional information about the I/O functionality of your mopier.

Table 4-12 presents the messages that will appear when you select each of the menu items.

Table 4-12	IO Menu
Menus		Item	Explanation
IO MENU		PARALLEL IO	The rate at which data is transferred to print a page.
		SPEED=[HIGH,LOW]
		IO TIMEOUT=	The time, measured in seconds, that the mopier
		[5 SEC,	waits before ending an incomplete print job. Once
		10 SEC,	the item is selected, press [+] repeatedly to choose
		15 SEC*,	the desired setting for best performance.
		20 SEC,
		30 SEC,
		60 SEC,
		120 SEC,
		180 SEC,
		240 SEC,
		300 SEC]
		IO BUFFER=	The portion of the mopier memory set aside to
		[AUTO*,OFF,ON]	hold incoming data. When this item is set to AUTO,
			the memory set aside for I/O buffering is
			automatically determined by the mopier based on
			available memory. When it is set to ON, the size
			can be manually adjusted. When it is set to OFF,
			no memory is set aside. This menu item will NOT
			appear in the menu until there is sufficient memory
			available to allow I/O buffering. For PCL, the
			standard 4 Mbytes of memory is sufficient. For
			PostScript it will take more than 12 Mbytes of
			memory. See Chapter 2 to learn how I/O buffering
			improves performance.
			Note: When you change the I/O buffer setting, all
			downloaded resources are deleted, unless they
			are stored on the mopier Hard Disk.
		IO SIZE=	Becomes visible only if IO BUFFER is set to ON. It is
		nnnK	used to set the size of the buffer. Once the item is
			selected, press [+] repeatedly to reach the
			increment value desired. If you hold down the [+]
			key, the values speed the increments.
* Factory default.

4-28 Mopier Control Panel

EN