HP 5SI manual Hardware Type

Table 7-2	Mopier Messages, continued
If the following errors persist, call your HP-authorized service provider.
Message		Description	Recommended Action
51.x ERROR		The mopier detected a laser sub-system	Turn the mopier OFF then
CYCLE POWER		problem.	ON again.
		51.1 Beam detection malfunction
		51.2 Laser malfunction
52.x ERROR		The mopier detected a scanning	Turn the mopier OFF then
CYCLE POWER		sub-system problem.	ON again.
		52.1 Scanner startup failure
		52.2 Scanner rotation failure
53.XY.ZZ MEMORY		An error occurred during configuration	Make sure your SIMM
ERR CYCLE POWER		and validation of SIMM memory:	board is installed correctly
		X (Hardware Type):	(see Appendix C, “Memory
			and Personality SIMM
		0: ROM
			Installation”). Replace the
		1: RAM
			SIMM that caused the error.
		Y (Hardware Device):	[Select[*] will allow you to
		0: Internal Memory	continue but the SIMM that
		1: SIMM Slot 1	caused the error will not be
		2: SIMM Slot 2	configured. If the SIMM
		3: SIMM Slot 3	device has more than one
		4: SIMM Slot 4	bank of memory, the good
		ZZ (Error Number):	banks will be configured.
		0: Unsupported memory
		1: Unrecognized memory
		2: Unsupported memory size
		3: Failed RAM test
		4: Exceeded maximum RAM size
		5: Exceeded maximum ROM size
		6: Invalid SIMM speed
		7: SIMM reporting information
		incorrectly
		8: SIMM RAM parity error
		9: Not used
		10: SIMM address conflict
		11: ROM out of bounds
		12: Could not make temporary mapping
54 2-SIDED ERROR		There is a Duplex Unit guide	Remove and re-install the
CHECK DUPLEXER		malfunction.	Duplexer Unit. Remove any
			jammed paper from the
			Duplexer Unit.
		Continued on the next page.

7-42 Maintenance and Troubleshooting

EN