HP 5SI manual Printing to the Mailbox with Stapler

Printing to the Mailbox with Stapler

The Mailbox with Stapler can work in one of three modes: mailbox mode, job separation mode, or stacking mode. The network or printer administrator determines which mode of operation is chosen through an HP network configuration utility, such as HP JetAdmin or HP LaserJet Utility. You need to set up your mopier driver to reflect the mode chosen by the administrator. Bidirectional environments automatically reflect the administrator’s choices in your printer driver.

The mopier control panel displays different names for the mailboxes and stapler, depending on which mode the driver is using.

In Mailbox Mode, if the	Then the physical
Control Panel says:	location is:
OPTIONAL OUTPUT BIN 1	Left Output Bin
OPTIONAL OUTPUT BIN	Mailbox 1-5
2 through 6
OPTIONAL OUTPUT BIN 7	Stapler Bin
In Job Separation or Stacking
Modes, if the Control Panel	Then the physical
says:	location is:
OPTIONAL OUTPUT BIN 1	Top Output Bin
OPTIONAL OUTPUT BIN 2	Mailbox bins
OPTIONAL OUTPUT BIN 3	Stapler Bin

	Selecting the Mailbox with Stapler through the Software
	You can select these output bins through your software application,
	mopier driver, or from the mopier control panel. It is better to designate
	the paper destination in your software or printer driver since you will
	control to which output bin your job is sent. Otherwise, follow the
	instructions below for setting the overall default mopier output bin
	selection.
	Where and how you make selections depends on your software
N o t e
	application or associated printer driver. The selection process may be
	available only from within the printer driver. See Chapter 3 or your
	application manual for more information.

5 Print Tasks

EN

Print Tasks 5-27