HP 5SI manual Allows you to select the mopier personality. Auto

Table 4-9	Configuration Menu, continued
Menu		Item	Explanation
CONFIGURATION		PERSONALITY=	Allows you to select the mopier personality. AUTO
MENU		[AUTO*,PCL,	is the default.
		POSTSCRIPT]
		AUTO CONTINUE=	Allows the mopier to resume printing after
		[ON*,OFF]	noncritical errors occur. If ON is selected, the
			mopier goes offline and the error message is
			displayed for ten seconds. After ten seconds, the
			mopier automatically returns to online.
		RESOURCE SAVE=	Sets resource saving to ON, OFF, or AUTO (which
		[AUTO*,OFF,ON]	automatically determines how much memory to
			use for each installed personality). When set to
			ON, you can select a specific amount of memory
			for resource saving.
		PCL MEM=nnnnnK	This item becomes visible only if Resource Save is
		or	set to ON. The value nnnnnK indicates the number
		POSTSCRIPT MEM=	of KBytes of memory reserved for that personality.
		nnnnnK	The choices for this item range from 0 to the total
			amount of available memory in the mopier in
			100-KByte increments. Press [+] repeatedly to
			increase reserved memory.
		TONER LOW=	This item allows you to make the choice to stop or
		[STOP*,CONTINUE]	continue printing after the mopier detects that
			toner is low. When toner runs out, the printed page
			may be blank.
		PAGE PROTECT=	PAGE PROTECT appears after a 21 PRINT OVERRUN
		[ON,AUTO*]	error has occurred. Try to simplify the format of the
			job. If you must print the job “as is,” set PAGE
			PROTECT to ON, then later return it to AUTO. Do not
			leave PAGE PROTECT set to ON as it will degrade
			performance.
* Factory default.

4 Mopier Control Panel

EN Mopier Control Panel 4-25