
Initialization Commands
Host Connection
Load Winsock On Start-up
Registry Entry: None
Command Line: -LW
Default Setting: Off
This will initialize the Winsock stack immediately when the emulator is started, enabling dialup over PPP or SLIP to gain a connection to a service provider.
Action On Host Connection Close
Registry Entry: ExitOnClose = "on" | emulator exits immediately |
ExitOnClose = "off" | emulator does not exit |
ExitOnClose = "connect" emulator attempts to reconnect
Command Line:
Default Setting: Message box displayed
When the host closes the connection or the connection fails, the emulator normally displays a message box giving you the option to reconnect, cancel or exit. These commands will disable the message box and cause the emulator to immediately perform the required option.
Disable New Session Warning Message Box
Registry Entry: SessionWarning = "off"
Command Line:
Default Setting: Enabled
A warning message is displayed by default when you attempt to open a new session while a session is currently open. These commands enable you to disable the message box so that the emulator automatically closes the current session and opens the new session.