HP Thin Client t5510 Wyse Settings, Wyse, Lines, Settings, Set Tabs, Tab Stops, Terminal Settings

Setup Menus

Wyse Settings

This dialog box is displayed by selecting Wyse in the Settings menu. Note that some of the settings apply to the TVI 910+, TVI 920, TVI 925, ADDS A2 and HZ 1500 emulations in addition to the Wyse emulations. Also, some settings may not apply to the particular Wyse emulation currently running. Selecting a setting that is not applicable to the current emulation will cause the emulator to use the default setting for that emulation when the dialog box is exited.

Note: The Tab Stops dialog box displayed by clicking the Set Tabs button is described later in this chapter, after the Terminal Settings description.

Lines

Factory default: 24

This option applies to the WY-50+ and WY-60 emulations and specifies the number of data lines displayed on the screen below the status line. Note that the other emulations only support 24 lines and a label line.

2424 data lines and a label line at the bottom.

2525 data lines but no label line.

4242 data lines and a label line at the bottom.

4343 data lines but no label line.

5-32