Lantronix SLC 8000 manual Host Lists, To add a host list, Chap Handshake, Password/ Retype

	8: Device Ports
Dial-back Retries	For dial-back and CBCP Server, the number of times the SLC unit will retry the
	dial-out portion of the dialing sequence if the first attempt to dial-out fails.
Timeout Logins	If you selected text mode, you can enable logins to time out after the
	connection is inactive for a specified number of minutes. The default is No. This
	setting only applies to text mode connections. PPP mode connections stay
	connected until either side drops the connection. Disabled by default.
Negotiate IP Address	If the SLC and/or the serial device have dynamic IP addresses (e.g., IP
	addresses assigned by a DHCP server), select Yes. This is the default.
	If the SLC unit or the modem have fixed IP addresses, select No, and enter the
	Local IP (IP address of the internal modem) and Remote IP (IP address of the
	modem).
Authentication	Enables PAP or CHAP authentication for modem logins. PAP is the default.
	With PAP, users are authenticated by means of the Local Users and any of the
	remote authentication methods that are enabled.
	With CHAP, the CHAP Handshake fields authenticate the user.
CHAP Handshake	The Host/User Name (for UNIX systems) or
	Secret/User Password (for Windows systems) used for CHAP authentication.
	May have up to 128 characters.
CHAP Auth Uses	For CHAP authentication, determines what is used to validate the CHAP host/
	user sent by the remote peer: either the CHAP Host defined for the modem, or
	any of the users in the Local Users list.
Enable NAT	Select to enable Network Address Translation (NAT) for dial-in and dial-out
	PPP connections on a per modem (device port, USB port, or internal modem)
	basis. Users dialing into the SLC unit access the network connected to Eth1
	and/or Eth2.
	Note: IP forwarding must be enabled on the Network - Settings page for NAT
	to work.
Dial-out Number	Phone number for dialing out to a remote system or serial device. May have up
	to 20 characters. Any format is acceptable.
Remote/Dial-out Login	User ID for authentication when dialing out to a remote system, or if a remote
	system requests authentication from the SLC module when it dials in. May have
	up to 32 characters.
Remote/Dial-out	Password for authentication when dialing out to a remote system, or if a remote
Password/ Retype	system requests authentication from the SLC unit when it dials in. May have up
	to 20 characters.
Restart Delay	The number of seconds after the timeout and before the SLC module attempts
	another connection. The default is 30 seconds.

6. Click Apply.

Host Lists

A host list is a prioritized list of SSH, Telnet, and TCP hosts available for establishing incoming modem connections or for the connect direct command on the CLI. The SLC unit cycles through the list until it successfully connects to one.

To add a host list:

1. Click the Devices tab and select the Host Lists option. The following page displays:

SLC™ 8000 Advanced Console Manager User Guide 130